What does EC mean on my Frigidaire dehumidifier?

The EC code means the sealed system and condenser is defective and the unit is not repairable. The coils are either freezing and stop functioning or just not condensing at all. Frigidaire warranties the sealed system for 5 years and will replace it for you, if you contact them.

Ambient temperature error

Similarly, what does the code fo mean on a Frigidaire dehumidifier? 1-10 of 11 Answers. It means that the sensor is going bad or went bad. Cut the sensor from the attached wires.

Likewise, how do you fix an EC error on a Frigidaire dehumidifier?

  1. Check that the filter in the unit is clean.
  2. Check that the room temperature is above 41 degrees.
  3. Check that the humidity isn’t set too low, recommended humidity is 45~50%
  4. Make sure that the unit has plenty of space all around to allow for sufficient air circulation.

What is EC error in AC?

An EC error code on a mini split indicates a Refrigerant Leakage Detection Error. This means the system has detected a leak. While there may be a leak in the unit keep in mind sensors and boards also can malfunction.

What does EC mean on a heater?

Ecn or Ec is Alternating with Temp: The Spa is Operating in the “Economy” (Ecn or Ec) Heating Mode. The Water Temperature is sampled Only during Programmed Filter Cycles. The Heater will only operate and Heat up to Set Temperature during the Filter Cycles.

What does p1 mean on a dehumidifier?

auto defrost mode

What does e2 mean on Haier dehumidifier?

E2. Indicates the air filter is dirty and needs cleaning. Clean filter in warm water (NOT HOT) with a mild detergent. DO NOT use any chemicals cleaners. Allow the filter to air dry and reinstall in the unit.

Does Home Depot sell dehumidifiers?

Overview. The Perfect Aire 70 Pint Dehumidifier features soft-touch electronic pad controls, a 70 pint per day water removal capacity and can cover up to approximately 4,500 sq. ft. The unit also has two fan speeds, a 12.7 Pint capacity bucket with handle and a minimum operating temperature of 41°F.

What does f0 error code mean?

The F0 error code is indoor ambient sensor fault(after researching online, bc of course they didn’t come with an installation or service manual ).

How do you clean a Frigidaire dehumidifier?

How To Clean the filter on a Frigidaire Dehumidifier. To clean the filter, you remove it first. To remove the filter properly, pull the tabs using your hands in order not to scratch them and then take out the filter. Then run the filter under clean water then dry it.

Why is my Frigidaire dehumidifier not collecting water?

If your dehumidifier is not collecting water even though the room temperature is over 65 degrees Fahrenheit, there may be an issue with the capacitor in the compressor circuit. The compressor circulates refrigerant through the unit to remove moisture from the air, which collects in the bucket.

How do you reset the filter on a Frigidaire dehumidifier?

The FILTER RESET light will illuminate after 250 hours of operation. At this time refer to the care and cleaning section to remove and clean the filter. Once the filter has been cleaned, to extinguish the light simply press the FILTER button.

Is my Frigidaire still under warranty?

To check registration, locate the serial number from your Frigidaire air conditioner, heat pump or gas furnace. Click “Register Your Warranty,” and enter your serial number in the top right hand corner. Please call 1-800-422-4328 to confirm your warranty coverage.

How do I clean the filter on my dehumidifier?

To clean: Remove the bucket. Remove the filter according to the instructions in the Owner’s Manual. Download a copy of the Owner’s Manual. Clean the filter with warm, soapy water. Rinse well and allow to dry complete before replacing. Reset the filter reminder timer by pressing the button for 3 seconds.